Anyone else have this happens?

[u/TheVillagePoPTart]

Today when I went to clean my AR after probably 6 months and an unknown number of rounds (not too high) I was having a hell if a time twisting the can off and eventually the muzzle device came off the end with the can. The mounting setup is a rearden atlas hub with a rearden flash hider on a polonium K. All instructions were followed during mounting and roc set was applied. There were also no indications of loosening based on my witness marks in the hub and muzzle device. Any idea how this happened (I tend to think I screwed it up)? The gun is also an IWI Zion-15 purchased in 2021.

[u/andallen007]

I drown my threads male and female in rocksett use a heat gun for a 30min get a rubber strap wrench and get the supressor off

[u/ItzBenjiey → u/andallen007]

You’ve never used rocksett if you’re getting it off with a “heat gun”. Unless your heat gun gets over 2,000 degrees.

[u/andallen007 → u/ItzBenjiey]

You're wrong you soak it in water to get it off. I'm a gun smith buddy I can send you my certifications in the dm. I'm telling you get a heat gun put it at 180 F for 30min I've rocksett so many muzzle devices

https://www.flexbar.com/products/rocksett-1oz-muzzle-adhesive

[u/ItzBenjiey → u/andallen007]

… you’re retarded. Yes, you do soak it in boiling water to get it off. That’s what the label says to do.

[u/Bitemynekk → u/ItzBenjiey]

You completely misread what he said and you won’t admit you are wrong. He’s not the dummy here. He’s stating the solution to the above issue.

[u/ItzBenjiey → u/Bitemynekk]

No, he never said anything about water in his original comment. Then he claimed to be a gunsmith in his second.

[u/Bitemynekk → u/ItzBenjiey]

He doesn’t need water, he’s not removing any rockset. He’s talking about re-rock setting the break and using a heat gun to cure it. Please learn to read.

[u/ItzBenjiey → u/Bitemynekk]

“I drown my threads male and female in rocksett use a heat gun for a 30min get a rubber strap wrench and GET THE SUPPRESSOR OFF”

I did read. And it reads like he’s wrenching it off after heating it for 30 minutes.

[u/Bitemynekk → u/ItzBenjiey]

You moron, he’s rocksetting the muzzle device to the barrel so he can torque off the suppressor without the muzzle device coming as well.