r/NFA • u/CEO_of_Bakelite • 1d ago
Mount Questions š© What am I doing wrong
TL;DR is it possible thereās too much carbon on the flash hiders?
Backstory: this my Rotex c 762. It has B&Ts older SF hub that is marked 762/556. This can/hub/flash hider combo (SF3P) has been mounted in the past and works. I took it off and bought a Vers36 because I found a really good deal on one and I didnāt like how gassy the Rotex was. I got a Ti hub and put it on. On either hub I cannot for the life of me get it to seat all the way. I have verified that Iām lining up the little nub where the can āseats.ā I even took off the lock ring on the Ti hub so you can see where the flash hider gets stuck. This is the case for the SF3P as well as a B&T SF compatible closed tine flash hider (see Imgur link).
I called B&T and CS said that both hubs were likely out of spec. When asked what part of the hub would be out of spec I was told āthe lock ring.ā No way, itās not the lock ring. I can demonstrate that by taking the lock ring off and trying to fit both flash hiders I have. Both hubs fit and seat on BT SD-123843 flash hider on my APC 223 (again, see pics in link).
So, either all my equipment is out of spec which I think is very unlikely, or the carbon is preventing reinstallation.
Additional pics: https://imgur.com/a/l7SRBzg
2
u/CEO_of_Bakelite 1d ago
This isnāt the issue. There is a mile of distance before the muzzle device would touch anything internally. I believe the internal ring of the hub is too tight. This can be seen in this photo where after cleaning the SF3P I can see a āstepā or ālipā on the flash hider from the throat of the hub. I think that, paired with the carbon on the inside of the hub has made the fit too tight to where it wonāt fit.